Sony XDCAM PMW-160, Service Manual

Page: 68 / 132

2-14. Front Lens
2-14-1. Front Lens Assembly
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery” .)
2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer” .)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly” .)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly” .)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly” .)
6. Remove the SxS slot assembly. (Refer to “2-7-1. SxS Slot Assembly” .)
7. Remove the front panel assembly. (Refer to “2-8-1. Front Panel Assembly” .)
8. Remove the rear panel assembly. (Refer to “2-9. Rear Panel Assembly” .)
9. Remove the IO-255 assembly. (Refer to “2-11. IO-255 Board” .)
10. Remove the DCP-61 board. (Refer to “2-12. DCP-61 Board” .)
11. Remove the handle assembly. (Refer to “2-13-1. Handle Assembly” .)
Procedure
1. Remove the two precision screws (P2.6 x 5) to detach the bracket H.
2. Remove the three precision screws (M2 x 4) to detach the bracket S.
3. Remove the four precision screws (P2.6 x 5) to detach the front lens assembly.
Precision screws
(P2.6 x 5)
Precision screws (P2.6 x 5)
Precision screws
(P2.6 x 5)
Bracket H
Bracket S
M2 x 4
Front lens assembly
4. Install the removed parts by reversing steps of removal.
2-14-2. Prism Block/Lens Unit
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery” .)
2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer” .)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly” .)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly” .)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly” .)
6. Remove the SxS slot assembly. (Refer to “2-7-1. SxS Slot Assembly” .)
PMW-160/PMW-150/PMW-EX260
2-38