Sony XDCAM PMW-160, Service Manual

Page: 52 / 132

2-12. DCP-61 Board
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery” .)
2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer” .)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly” .)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly” .)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly” .)
6. Remove the SxS slot assembly. (Refer to “2-7-1. SxS Slot Assembly” .)
7. Remove the front panel assembly. (Refer to “2-8-1. Front Panel Assembly” .)
8. Remove the rear panel assembly. (Refer to “2-9. Rear Panel Assembly” .)
9. Remove the IFC-13 board. (Refer to “2-10. IFC-13 Board” .)
10. Remove the IO-255 board. (Refer to “2-11. IO-255 Board” .)
Procedure
1. Remove the four precision screws (M2 x 4) to detach the HDMI bracket.
2. Disconnect the coaxial cable from the connector CN2200 on the DCP-61 board.
Precision screws
(M2 x 4)
Precision screws
(M2 x 4)
HDMI bracket
Coaxial cable
CN2200
3. Remove the gasket main M.
4. Disconnect the harness from the connector CN2301 on the DCP-61 board.
5. Disconnect the HN-387 board from the connector CN2300 on the DCP-61 board.
6. Disconnect the HN-384 board from the connector CN2402 on the DCP-61 board.
7. Disconnect the three fine-wire coaxial cables from the three connectors CN100, CN101 and CN102 on the DCP-61
board.
PMW-160/PMW-150/PMW-EX260
2-22