Sony XDCAM PMW-160, Service Manual

Page: 46 / 132

2-8. Front Panel
2-8-1. Front Panel Assembly
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery” .)
2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer” .)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly” .)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly” .)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly” .)
Procedure
1. Disconnect the harness from the connector CN401 on the IFC-13 board.
2. Disconnect the flexible board from the connector CN103 on the SWC-54 board.
3. Disconnect the harness from the connector CN104 on the SWC-54 board.
4. Remove the Tape 60.
5. Remove the two tapping screws (2 x 5) to detach the front panel assembly.
Tapping screws
(2 x 5)
Front panel assembly
Harness
Flexible board
CN103 (SWC-54 board)
CN104 (SWC-54 board)
Lever
IFC-13
board
CN401
Harness
ND filter knob
Tape 60
Note
When installing the Front panel assembly, fit the ND filter knob with the lever.
6. Install the removed parts by reversing steps of removal.
PMW-160/PMW-150/PMW-EX260
2-16