Ov
er
v
ie
w
Location and Function of Parts and Operation
7
Rear
4
DC IN (DC power input) connector (12-pin)
You can connect a CCXC-12P05N camera cable to input
the +12 V DC power supply. The pin configuration of
this connector is as follows.
(For details on the pin arrangement, see the following
Figure.)
* Signal output from the Tenth pin of *12 pins
connector
You can select one of the following signals according
to the setting.
Ground / DVAL output / Exposure pules output
The default setting in the factory is Ground.
5
DIGITAL IF (Interface) connector (26-pin)
Camera Link Base Configuration: 1 tap
You can connect a Camera Link cable to this connector
to control a camera module from a host device utilizing
the serial communication protocol while outputting a
video signal from the camera module. You can input the
external trigger signal via the 26-pin connector and
operate a camera module in the external trigger mode.
The pin configuration of this connector is as follows.
(For details on the pin arrangement, see the following
Figure.)
Note
When you operate a camera module by inputting an
external trigger signal via the 26-pin connector, make
sure to input external trigger signals that meet the
following specifications to both the two pins.
Specifications for the External Trigger Signal
Amplitude:
LVDS using a 3.3 volt IC
Connections: Input a TRIG (–) signal to the 9th
pin.
Input a TRIG (+) signal to the 22nd
pin.
Polarity:
positive
5
4
4
DC IN (DC power input) connector (12-pin)
5
DIGITAL IF (Interface) connector (26-pin)
Pin No.
Signal
Pin No.
Signal
1
Ground
7
NC
2
+12 V DC
8
Ground
3
Ground
9
NC
4
NC
10
Signal* output
5
Ground
11
Triger pulse input
6
NC
12
Ground
Pin No. Signal
Pin No. Signal
1
INNER_SHIELD
(Ground)
14
INNER_SHIELD
(Ground)
2
X0– output
(Signal)
15
X0+ output (Signal)
3
X1– output
(Signal)
16
X1+ output (Signal)
4
X2– output
(Signal)
17
X2+ output (Signal)
5
XCLK– output
(Signal)
18
XCLK+ output
(Signal)
6
X3– output
(Signal)
19
X3+ output (Signal)
7
Ser TC+ (Signal)
20
Ser TC– (Signal)
8
Ser TFG– (Signal)
21
Ser TFG+ (Signal)
9
TRIG– input
(Signal)
22
TRIG+ input
(Signal)
10
NC
23
NC
11
NC
24
NC
12
NC
25
NC
13
INNER_SHIELD
(Ground)
26
INNER_SHIELD
(Ground)