XAV-AX210
6
Sony CONFIDENTIAL
For Authorized Servicer
3. Connect the power cord to the regulated DC power supply, and
turn the power on this unit.
Note 4:
It is not necessary to install the top cover and mechanism deck that
were removed in step 1.
+
–
Regulated DC
power supply
top cover
mechanism deck
4. Press the [OFF] button on the remote commander to the state
of source off, enter the destination setting mode by pressing the
buttons on the remote commander in order of the [4]
t
[5]
t
[6] (press only the [6] button for two seconds).
(Displayed screen in the above
fi
gure are example)
5. The following screen is displayed and the destination setting
mode becomes effective.
<DESTINATION SETTING MODE>
0
0 0 0 0 7
UC:*00001
FT(JPN):*00007
(Displayed characters/values in the above
fi
gure are example)
6. Input the 6 digits destination code (000001).
Press the [
V
] or [
v
] button on the remote commander to select
“0” with the 6th digit and press the [
b
] button on the remote
commander.
Press the [
V
] or [
v
] button on the remote commander to select
“0” with the 5th digit and press the [
b
] button on the remote
commander.
Press the [
V
] or [
v
] button on the remote commander to select
“0” with the 4th digit and press the [
b
] button on the remote
commander.
Press the [
V
] or [
v
] button on the remote commander to select
“0” with the 3rd digit and press the [
b
] button on the remote
commander.
Press the [
V
] or [
v
] button on the remote commander to select
“0” with the 2nd digit and press the [
b
] button on the remote
commander.
Press the [
V
] or [
v
] button on the remote commander to select
“1” with the 1st digit and press the [ENTER] button on the re-
mote commander, then the unit reboots and returns to the normal
condition.
Note 5:
The digit return by pressing the [
B
] button on the remote command-
er.
Note 6:
The destination code cannot be inputted by operation of main unit.
Be sure to input the destination code by using the remote commander.
[
b
] press to
advance the digit.
[
B
] press to return
the digit.
[
V
] press to select
the alphanumeric
characters.
[
v
] press to select
the alphanumeric
characters.
Press [ENTER] by the
1st digit to complete
the setting.
<DESTINATION SETTING MODE>
0
0 0 0 0
1
UC:*00001
FT(JPN):*00007
0 0 0 0 0 1
1st
2nd
3rd
4th
5th
6th
6 digits
7. Refer to step 2 and after in “DESTINATION CHECKING
METHOD” on page 5, and con
fi
rm a correct destination was set.
8. Disconnect the power cord from the regulated DC power supply,
and turn the power off this unit.
+
–
Regulated DC
power supply
– Continued on next page –
SYS SET
2018/09/12 22:50:21 (GMT+09:00)
