Settings
NOTE
Initiating Setting Mode
In Setting mode, you can change the
transmission channel/frequency and
the RF output power level, or +48V
power supply.
To Enter Setting Mode
While holding down the SET button,
set the POWER switch to ON.
The transmitter enters Setting mode
and the indication before the
transmitter was previously turned
OFF flashes on the display section.
Each time you press the SET button,
the setting items are cyclically
switched as shown below.
•
The transmitter cannot transmit in
Setting mode.
•
Make sure that the channel selected
on the transmitter is the same as
that selected on the tuner being
used in the same system.
•
Depending on the noise or
interference conditions, all
selectable channels may not be
usable. If necessary, you can
determine which channels are
usable by cycling the channel
selection through a number of
channels on the tuner with the unit
set to OFF. Those channels for
which the RF indicator on the tuner
does not light are usable.
•
If there is a TV broadcasting station
near by, do not use the station’s
channel.
•
The transmitter may not operate
correctly if it is turned on
immediately after being turned off
in Setting mode. Wait for a few
seconds before turning the power
on again.
•
The channel numbers and
frequencies of your transmitter are
shown on the
“Sony Wireless
Microphone System Frequency
List”
supplied with the manual.
MIC or LINE
10
