WRT-800A (AU)
2-3
2-2. Notes When Assembling Parts
1.
Positive (+) polarity terminal plate, battery coil spring
2. RF-87 board
Align the 4 cut-outs of the board
with the 4 protrusions as shown
by the arrow, and attach
the RF-87 board under
the 2 claws shown
by the asterisk
(*) mark.
RF-87 board
Chassis B
Chassis B
Fit and insert the
RF-87 board in the
hole of the chassis B
while taking care not to
bend the legs of the
LED indicator.
RF-87 board
*
*
3.
AU-258 Board
AU-258 board
Chassis A
Insert it beneath the positive (+) polarity terminal plate.
AU-258 board
Chassis A
Positive (+) polarity terminal plate
When attaching the AU-258 board to the chassis A,
insert the AU-258 board in the order of
1
and
2
in the direction of the arrow as shown.
n
The chassis A is made of material
which is fragile to heat. Avoid applying
high temperature for extended period
during soldering.
Tip of the positive (+) polarity terminal plate
L202
Solder here.
Chassis A
Be careful not to pinch the harness
between the chassis A and the
AU-258 board.
Align the 4 cut-outs of the board with the 4 protrusions
as shown by the arrow, and attach the AU-258 board
under the 3 claws shown by the asterisk (*) mark.
2
1
*
*
*
Battery coil spring
Insert the battery
coil spring until it
enters beneath the
protrusion as shown
by the arrow.
Battery coil spring
Positive polarity terminal plate
1
Bend the leg by 135 degrees to the
side as shown (in the direction of
arrow) in which center of the
positive (+) polarity terminal plate
is dented.
2
Insert the positive (+) polarity
terminal plate deep enough until it
contacts with the chassis A which
is shown by the illustration.
Chassis A
Lug
Cut.
Adhesive sheet
Apply following the bond.
Sony bond master
(Part No. 7-432-916-01)