14
Installing and Connecting the TV
VIDEO (yellow)
AUDIO-R (red)
VCR
S VIDEO
Rear of TV
75-ohm coaxial cable (supplied)
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2
Connect the CATV cable to the VCR’s VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
4
Using AUDIO and S VIDEO cables, connect the satellite receiver’s
AUDIO and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO
IN jacks.
5
Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Note
To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the
(Setup) menu (See page 12).
Tips
• You can also use the VIDEO 2 IN jacks to connect your VCR.
• Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for
instructions.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
AUDIO-L (white)
AUDIO cable
(not supplied)
Satellite receiver
Cable
S VIDEO cable
(not supplied)
AUDIO cable
(not supplied)
75-ohm coaxial
cable (supplied)
S VIDEO cable
(not supplied)
Satellite
antenna
cable
Summary of Contents for WEGA KLV 23HR2
Page 83: ...Additional Information 83 ...