Attaching the Projection Lens
24
Removing the default image
surface pins
Note
Make sure to remove the two default image surface pins
before use. Otherwise, the projection lens may be
damaged.
1
Pull the two default image surface pins on the
ceiling side and on the side of the projection lens
straight forward.
If the pins are too tight to pull out, use tools such as
pliers.
You can store the removed pins by putting them
into the screw holes near the removed positions.
You can confirm the default position of the image
surface using the default image surface pins. For
details, see “Confirmation method of the default
position of the image surface” (page 30).
Attaching the Projection Lens
VPLL-3003
Notes
• When attaching the projection lens, put the projector
on the floor.
• When attaching the projection lens, do not press the
LENS RELEASE button.
1
Fully insert the projection lens with the index on the
lens facing toward the top surface of the projector.
Note
When attaching the projection lens, carry it grasped
with both hands as shown in the illustration.
2
Rotate the lens clockwise until it clicks.
Default image surface
pin A
Default image
surface pin B
Screw holes to store the default
image surface pins
Index
Top of surface of the projector
