11
(EN)
Rear
1
Control panel
You can turn the control panel by 180 degrees when
installing the projector upside-down, such as for
ceiling installation. For details, consult with qualified
Sony personnel.
For details on the control panel key arrangement, see
“Control panel” on pages 9 (EN) and 10 (EN).
2
MAIN POWER switch (
O
ON/
o
OFF)
Turns the main power on and off.
3
AC IN socket
Connect the supplied AC Power cord.
4
CONTROL S IN/OUT jacks (stereo minijack)
Connect to the control S jacks of other Sony
equipment.
CONTROL S IN/PLUG IN POWER (DC 5 V
output) jack: Connects to the CONTROL S
OUT
jack of the supplied Remote Commander when
using as a wired Remote Commander. In this case,
you do not need to install the batteries in the
Remote Commander, since the power is supplied
from this jack.
CONTROL S OUT jack: Outputs the control S
signal.
(Continued)
1
2
3
4
5
6 7
8 9
!º
!¡
!™
!£
U
+
–
+
–
+
–
+
–
u
g
0
0
CONTROL S
OUT
IN
PLUG IN
POWER
REMOTE
RS-422A
0
INDEX
TRIG
0
S VIDEO
AUDIO OUT
VIDEO
R/R-Y
AUDIO IN
INPUT A
G/Y
B/B-Y SYNC/HD
Y IN
C IN
IN
OUT
IN
OUT
VD
AUDIO IN
REMOTE 1
IN
OUT
MODE
L
(MONO)
(MONO)
R
L
R
L
R
Note
When connecting the remote commander cable to the
CONTROL S IN jack, the remote control detectors
will not work.
5
REMOTE RS-422A connector (D-sub 9-pin,
female)
Connect to a computer to operate the projector from a
computer. This expands system capability via the RS-
422A interface. Before using this connector, remove
the red cap attached at the factory.
6
INDEX switches
Set the index number of the projector when using
multiple projectors. You can set the numbers between
“01” and “99”. It is set to “01” at the factory.
Notes
• Do not set the index number to “00”. If it is set to
“00”, the projector cannot be controlled with the
Remote Commander.
• Do not set the index number to “9” if you use the
supplied Remote Commander for controlling the
projector.
