Sony VPL-V W100, Operating Instructions Manual

Page: 62 / 259

GB
62
Troubleshooting
Caution messages
Please replace the Lamp/
Filter.
End of Lamp/Filter life.
Lamp off in 1 min.
c
It is time to replace the lamp. Replace the lamp. (
1
page 63)
c Also, replace the air filter too. ( 1 page 67)
If this message appears again after you replace the lamp and filter,
the lamp replacement process is not complete. Check the lamp
replacement process. (
1
page 63)
Please clean the filter.
c
It is time to clean the air filter. Clean the air filter. (
1
page 66)
Please clean the filter. Have
you finished? Yes
V
No
v
c It is time to clean the air filter. Clean the air filter. ( 1 page 66)
c
If you cleaned the air filter, select “Yes.” If you did not clean the
air filter, select “No.”
Probably use in high
altitude. Switch to high
altitude mode on? Yes
V
No v
c
When using the projector at an altitude of 1,500 m or higher:
select “Yes” to set to “High Altitude Mode”. (
1
page 52)
c If this message is displayed when using the projector at an
altitude of less than 1,500 m: check to see if nothing is blocking
the ventilation holes. (
1
page 14)
Note
When you selected “Yes,” the number of turns of the fan increases.
Message Cause and Remedy
c
No signal is input in the selected input. Check connections. (
1
page 18)
Not applicable!
c
Press the appropriate button.
Please check Network
Setting. c Invalid values, such as a blank, are entered in the
Network Setting window. Enter the correct values. (
1
page 52)
x