39
(GB)
Symptom
Warning messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
Caution messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
Cause
Remedy
The LAMP/COVER indicator
flashes.
The lamp cover or the air filter cover is
detached.
Attach the cover securely
(see pages 36 (GB) and
37 (GB)).
The LAMP/COVER indicator
lights up.
The lamp has reached the end of its life.
Replace the lamp
(see page 36 (GB)).
The lamp becomes a high temperature.
Wait for 90 seconds to cool down the lamp and
turn on the power again
(see page 22 (GB)).
The TEMP/FAN indicator
flashes.
The fan is broken.
Consult with qualified Sony personnel.
The TEMP/FAN indicator
lights up.
The internal temperature is unusually
high.
Check to see if nothing is blocking the ventilation
holes.
The Remote Commander
does not work.
The Remote Commander batteries are
dead.
Replace with new batteries
(see page 16 (GB)).
The COMMANDER ON/OFF switch is
set to the OFF position.
Set the switch to ON position
(see page 16 (GB)).
The cable is connected to the CONTROL
S OUT jack.
Disconnect the cable
(see page 16 (GB)).
The front/rear remote control detector is
near the fluorescent lamp.
Change the setting of SIRCS RECEIVER in the
SET SETTING menu
(see page 32 (GB)).
The laser pointer is not
emitted.
The batteries are dead.
Replace with new batteries
(see page 16 (GB)).
The Remote Commander is used as
wired without batteries.
Install batteries
(see page 16 (GB)).
The joystick, R CLICK, or L
CLICK key does not function.
The mouse port on the computer does
not recognize the mouse cable.
Restart the computer.
Meaning
Remedy
High Temperature!
Power off in 1 min.
Internal temperature is too high.
Turn off the power.
Check to see if nothing is blocking the ventilation
holes.
Frequency is out of range!
This input signal cannot be projected as
the frequency is out of the acceptable
range of the projector.
Input a signal that is within the range of the
frequency.
The resolution setting of the output
signal of a computer is too high.
Set the setting of output to the SVGA
(see page 18
(GB)).
Meaning
Remedy
NO INPUT
No input signal
Check connections.
Not applicable!
You have pressed the wrong key.
Press the appropriate key.
Please check INPUT-A in SET
SETTING.
You have input RGB signal from the
computer when INPUT-A in the SET
SETTING menu is set to COMPONENT.
Set INPUT-A correctly.
