Sony VPL-SC50E, Operating Instructions Manual

Page: 36 / 120

36
(EN)
NO INPUT
Not applicable!
High Temperature!
Power off in 1 min.
Frequency is out of range!
Symptom Cause Remedy
The LAMP/COVER indicator
flashes.
The LAMP/COVER indicator
lights up.
The TEMP/FAN indicator
flashes.
The TEMP/FAN indicator
lights up.
The Remote Commander
does not work.
The laser pointer is not
emitted.
The joystick, R CLICK, or L
CLICK key does not function.
Warning messages
Use the list below to check the meaning of the messages displayed on the screen.
Message Meaning Remedy
Internal temperature is too high.
This input signal cannot be projected as
the frequency is out of the acceptable
range of the projector.
The resolution setting of the output
signal of a computer is too high.
Turn off the power.
Check to see if nothing is blocking the ventilation
holes.
Input a signal that is within the range of the
frequency.
Set the setting of output to the SVGA (see page 18
(EN)).
Caution messages
Use the list below to check the meaning of the messages displayed on the screen.
Message Meaning Remedy
No input signal
You have pressed the wrong key.
Check connections.
Press the appropriate key.
The lamp cover or the air filter cover is
detached.
The lamp has reached the end of its life.
The lamp becomes a high temperature.
The fan is broken.
The internal temperature is unusually
high.
The Remote Commander batteries are
dead.
The COMMANDER ON/OFF switch is
set to the OFF position.
The cable is connected to the CONTROL
S OUT jack.
The front/rear remote control detector is
near the fluorescent lamp.
The batteries are dead.
The Remote Commander is used as
wired without batteries.
The mouse port on the computer does
not recognize the mouse cable.
Attach the cover securely (see pages 33 (EN) and
34 (EN)).
Replace the lamp (see page 33 (EN)).
Wait for 90 seconds to cool down the lamp and
turn on the power again
(see page 21 (EN)).
Consult with qualified Sony personnel.
Check to see if nothing is blocking the ventilation
holes.
Replace with new batteries
(see page 16 (EN)).
Set the switch to ON position (see page 16 (EN)).
Disconnect the cable (see page 16 (EN)).
Change the setting of SIRCS RECEIVER in the
SET SETTING menu
(see page 29 (EN)).
Replace with new batteries (see page 16 (EN)).
Install batteries (see page 16 (EN)).
Restart the computer.
Troubleshooting