37
Blend
Settings
Configure the Edge Blending setting for the top, bottom, right, and left of
the screen respectively.
Left/Right/Top/Bottom:
Set the Edge Blending effect for each position.
Edge Blending:
Set “On” to set “Blending Range” or “Blend Start Pos.”
Blending Range:
Set the width where images are overlapped.
Blend Start Pos.:
Set the start position from which images are
overlapped.
Blend Cursor:
Displays the cursors at the start and end positions for edge
blending. When set to “On,” the cursors are displayed during Blend
settings.
Start Pos. Color:
Select the color of the cursor that indicates the start
position.
End Pos. Color:
Select the color of the cursor that indicates the end
position.
Reset:
Resets all of the Blend Settings values.
Blend Fitting
Finely adjusts the overlapped part.
Adjust:
Specify a position in the overlapped area and move image pixels.
Use
V
/
v
/
B
/
b
to select the position to adjust. Press the ENTER key to
determine the position and use
V
/
v
/
B
/
b
to move the image pixels
vertically/horizontally so that neighboring images overlap.
Reset:
Resets all of the Blend Fitting values.
Zone Black
Level Adj.
*4
*5 *6
Adjusts so that the overlapped part is not noticeably bright when a dark
image is displayed.
Select the correction zone “Adjust Zone 1” through “Adjust Zone 9,” and
set the adjustment values.
Zone Fitting:
Adjusts the area of each correction zone.
Adjust:
Specifies the position of the marginal line of each correction
zone.
Select the adjusting position using
V
/
v
/
B
/
b
. Press the ENTER key to
determine the position and use
V
/
v
/
B
/
b
to move the image pixels
vertically/horizontally so that the area of each correction zone is adjusted.
Reset:
Resets all of the Zone Fitting values.
Black Level Adj.:
Adjusts the brightness of each correction zone.
Reset:
Resets all of the Black Level Adj. values.
Reset:
Resets all of the Zone Black Level Adj. values.
Image Split
Off/Left-side Area/Right-side Area:
Divides the input signal from the
computer in half, and displays an enlarged image of the left-side or right-side
area on the screen.
*7
Image Flip
HV/H/V/Off/Auto:
Flips the projected image horizontally and/or
vertically according to the installation method.
High Altitude Mode
On/Off:
Set to “On” when using the projector at an altitude of 1,500 m or
higher. Continuing to use the wrong setting may affect component
reliability.
Filter Cleaning
Turns off the projector and cleans the air filter.
*8
Filter Box (Op)
Installed/Not Installed:
Set to “Installed” when using Projector Filter Box
(PK-F60FB1.)
Screen Aspect
16:10/16:9/4:3:
For switching the display area to suit to the screen.
Setting items
Description