46
Change the settings for the control protocol
on the Setup page.
Entered values will not be applied unless
you click on [Apply].
1
Click on [Advanced Menu] to display
the Setup page.
2
Click on [Advertisement] to display
the Advertisement page.
Start Advertisement Service:
Set
Advertisement to enabled or disabled.
Items for Advertisement are enabled
only when this function is enabled.
-Community:
Input the community
name for Advertisement and PJ Talk.
If the community name for
Advertisement is changed, the one for
PJ Talk will also be changed. Only
four alphanumeric characters can be
input. The factory default setting is
“SONY.” To avoid unwanted access to
the projector from other computers,
changing the community name of the
factory default is recommended.
-Port No.:
Input the transmit port of
Advertisement. The factory default
setting is “53862.”
-Interval:
Input the transmission
interval (seconds) of Advertisement.
The factory default setting is “30.”
-Broadcast Address:
Input the
destination of data via Advertisement.
If nothing is input, the data will be
broadcast in the same subnetwork.
3
Click on [ADCP] to display the ADCP
page.
Start ADCP Service:
Set ADCP to
enabled or disabled. Items for ADCP
are enabled only when this function is
enabled.
-Requires Authentication:
Set the
authentication for ADCP to enabled or
disabled. The password is the same as
that of the Web page administrator.
-Port No.:
Input the server port of
ADCP. The factory default setting is
“53595.”
-Timeout:
Input the time (seconds) until
ADCP communication is terminated
in case it is disconnected. The factory
default setting is “60.”
-Host Address:
Input the IP address that
the ADCP server is allowed to receive.
If no IP address is input, receiving
commands will be allowed from any
Setting the Control Protocol
of the Projector
Advanced Menu button
Advertisement button
ADCP button