17
Troubleshooting
Troubleshooting
Symptom
Cause and Remedy
The projector is not displayed
in the main window.
(Computer)
The computer is not displayed
in the PC list. (Projector)
• Projector Station for Air Shot is not installed in the computer.
c
Install it.
• The supplied wireless LAN card is not inserted into the slot of
the projector or a card other than the supplied one is inserted.
c
Insert the supplied wireless LAN card.
• The signal is extremely poor (the computer is distant from the
projector or there is an obstacle such as a concrete wall or a
steel partition/door between the computer and projector).
c
Place the computer and projector near to each other or ensure
there is no such intervening obstacle.
Simple Mode [On]
• Simple Mode of the projector or computer (Projector Station
for Air Shot) is not set to [On].
c
Set Simple Mode to [On].
• [Connected Projector] of the computer is not set to the
projector you want to connect.
c
Add or select the projector to be connected by using [Change
Projector] in Projector Station for Air Shot.
Simple Mode [Off]
• The wireless and network settings of the projector or computer
are not set correctly.
c
Check that the IP address, SSID, WEP, etc. settings are the
same as those of the connected equipment.
The computer and projector
are connected in Projector
Station for Air Shot but the
image cannot be projected on
the projector.
• The projector is set to a picture muting.
c
Press the PIC MUTING key on the remote commander to
release the muting.
• INPUT C is not selected on the projector.
c
Press the AIR SHOT key on the remote commander or select
INPUT C using the INPUT button.
• [Memory Stick] is selected in INPUT C.
c
Press the AIR SHOT key on the remote commander.
Some part of the image
displayed on the projector is
not correct.
The following application softwares may not be transported
correctly.
• Application software that uses DirectX
• Application software that plays back a movie
• Microsoft Office assistant
• Microsoft IME tool bar
• Tool tip displayed by mouse over
The image of one computer
cannot be projected on several
projectors. (Only one
projector is displayed in
Projector Station for Sir Shot.)
• Simple Mode [On] is used.
c
Set Simple Mode of the projector and computer (Projector
Station for Air Shot) to [Off] and set the nerwork and
wireless settings.
Summary of Contents for VPL-CX85
Page 21: ...Sony Corporation ...