14
Overview
Overview
IR
POWER
STANDBY
AC IN
MAIN POWER
ON
OFF
100~120V 15A 250V
200V~240V T6.3A 250V
R-Y
R
P
R
G
Y
B-Y
B
P
B
SYNC
HD
VD
INPUT A
ABL LINK
OUT
IN
TRIGGER
IN
PLUG IN
POWER
OUT
REMOTE
INDEX
RS-422A
CONTROL S
!º
!¡
!™
!£
1
2
3
4
5
6
7
8
9
Rear
1
Signal interface board attachment part (INPUT
B)
Attach an optional signal interface board IFB-40, IFB-
1000, etc.
2
INPUT A connectors (BNC type)
R/R-Y/P
R
, G/Y, B/B-Y/P
B
, SYNC/HD, VD
connectors: Connect to the outputs of a computer or a
video camera. According to the connected
equipment, the RGB (R, G, B), component (R-Y,
G, B-Y) or HDTV (P
R
, Y, P
B
) signal is selected.
3
TRIGGER connector (minijack)
When the projector is turned on, 12 V is output and
when it is turned off, 0 V is output. However, the
connector is not used as the power source since the
power is not output.
4
RS-422A REMOTE connector (D-sub 9-pin)
Used to expand the system connections using the RS-
422A interface.
Before using the connector, loosen the two screws to
remove the cap.
Location and Function of Controls
5
ABL (Automatic Brightness Limiter) LINK IN/
OUT jacks (minijack)
When connecting multiple projectors, connects the
ABL LINK OUT jack to the ABL LINK IN jack on
another projector. You can synchronize the brightness
limiting point among the projectors, allowing to make
the whole screen brightness uniform.
6
CONTROL S jacks
IN/PLUG IN POWER (5 V) jack (stereo minijack):
Connects to the CONTROL S OUT jack of other
Sony equipment. Also connects to the CONTROL
S OUT jack of the supplied remote commander
with the supplied remote control cable (stereo
cable) to be used as a wired remote control. In this
case, this jack supplys 5 V to the remote
commander as power source.
OUT jack (stereo minijack): Connects to the
CONTROL S IN jack of other Sony equipment.
Note
When using this jack, the remote control detector on
the projector does not function.
