32
VGX-XL3 Digital Living System
Important
: Then select
I heard sound from all my speakers
, even if you did
not hear sound from all your speakers. The You Are Done! screen displays.
7
Select
Finish
.
To complete Speaker Setup, you need to verify some Windows
®
settings.
1
Right-click the speaker icon in the Windows Notification Area and select
Playback Device
.
2
Depending on your computer system's digital sound output configuration,
select
Digital Output Device (S/PDIF and HDMI)
,
Digital Output Device
(HDMI)
, or
Digital Output Device (S/PDIF)
.
3
Click
Set Default
.
4
Click
Properties
.
5
Click the
Supported Formats
tab.
6
In the
Encoded formats
section, put a checkmark in the
Dolby Digital
box.
This setting works with Dolby Digital
and
DTS encoded surround
soundtracks.
Note:
Do not select DTS Audio as that setting only outputs 2-channel sound.
7
In the
Sample Rates
section, select a value that your A/V receiver or sound
decoder device can handle. A value of 48.0 KHz is usually a good default
setting.
8
Click the
Apply
, and then
OK
.
Step 4: Connecting to the Internet and Existing
Wireless Network
Wired Network
Use an RJ-45 cable. Connect one end to the Ethernet connector on the rear
panel of the VGX-XL3 and the other end to your cable or DSL modem router.
Start Media Center and from
Tasks
>
Settings
, go to
General
>
Windows
Media Center Setup
>
Set Up Internet Connection
. Then follow the on-
screen instructions.