Sony Vaio VGP-UHDM10, Operating Instructions Manual

Page: 16 / 27

16
VGP-UHDM10_2-897-915-11(1)
Using the drive (secure mode)
If you use the drive registered with wireless key, you need to perform the
following procedures each time you connect the USB cable to the
computer. Furthermore, you also need to operate them as below status.
• When restarting the computer
• When returning from hibernation
• When returning from standby mode
1
Turn on the computer then connect the USB cable (page
10).
The LOCK indicator lights and the blue light of the wireless key
receiver flashes.
z
Tips
• If you do not operate the hard disk drive for more than 8 seconds, while the blue
light of the wireless key receiver flashes, the hard disc drive turns off. In this case,
disconnect the USB cable and reconnect it.
• If you use the Windows 2000 operating system, when the hard disk drive turns off,
“Unsafe Removal of Device” appears.
2
Touch the wireless key receiver with either registered
wireless key.
The UNLOCK indicator lights and the drive is recognized by the
computer.
Note
The blue light may flash after recognizing the drive on some computers when
returning from hibernation mode or restarting. In this case, touch the wireless key
receiver with the wireless key again.