Sony UP25MD, Instructions For Use Manual

Page: 32 / 76

32
Making a Printout of Multiple Different Reduced Images
O
per
a
tio
n
Pressing the
M
,
m
,
<
or
,
button moves the
cursor one position by one position vertically or
horizontally.
2
Display the source image on the video monitor.
For detailed information on how to display the
source image, see step 3.
3
Press the CAPTURE button at the instant the
image you want to print appears.
The previously captured image is replaced with
the newly captured image.
To keep a previously captured image
Skip images that you want to keep by pressing the
M
,
m
,
<
or
,
button.
5
Press the PRINT button.
The four reduced images are printed on one sheet of
paper.
Whether white borders are attached depends on the
setting of SEPARATE in the LAYOUT SETUP menu.
(See page 32.)
If the printout is blurred
When you make a printout of a full image, or two or four
reduced images captured in memory in FRAME mode, the
images on a printout may be blurred. Should this occur,
change the memory mode setting to FIELD on LAYOUT
SETUP menu (“Selecting the memory mode” on page 27),
then print it again. Although the blur should be eliminated,
the ultimate print quality will be slightly degraded.
Note
Usually, it is recommended that you make printouts in
FRAME mode. Check the setting on the LAYOUT SET
UP menu.
Making a printout with white borders
The unit allows you to decide whether or not the images
are printed with white borders.
Note
This setting is also effective for the images which have
been captured.
1
Display the LAYOUT SETUP menu according to the
operations of step 1 described in “Selecting the
memory mode” on page 27.
2
Select SEPARATE by pressing the
M
or
m
button.
3
Select whether the images are printed with or without
white borders by pressing the
<
or
,
button.
a) F is attached to the type of printout at the printer operation
mode display section in the printer window display.
Example: 4F
4
Press the MENU button.
The normal screen appears.
Press the M , m , < or , button until the third cursor
blinks green.
Press the M , m , < or , button until a 3 appears.
When you want to Setting
Print the images without white borders. OFF
Print the images with white borders. ON
a)
Highlight SEPARATE in green by pressing the M or m
button.
Switch the desired setting to green by
pressing the
< or , button.