12
Preparation
Connecting the Computer
~
AC IN
The UP-D2600 connects to the Windows computer via the parallel interface.
Before connecting the computer, see “Important safeguards/notices for use in the
medical environments” on page 2.
Notes
• Turn off the power of each device before attempting to make any connections.
• Grab the connector at the end of the connecting cable, and firmly insert it into the
socket.
• Use the shielded cable that should be less than 3 meters and conforms to the
parallel specification, as the printer cable.
• To use the printer in ECP mode, use an interface cable in conformity to IEEE Std
1284.
Note
The parallel cable connection requirement can vary between different computers
and peripherals. For the details of your installation, refer to the manual of your
computer and peripherals.
Windows
computer
to
-
AC IN
to wall outlet
AC power cord
(supplied)
Fasten the clamps at both sides of the interface
connector to secure the printer cable.
Parallel data cable
(not supplied)
to Parallel interface
connector
