Mis
c
e
llan
eous
Error/Warning Messages
66
Warning Messages
In case of a warning, only warning messages appear. The
ALARM lamp does not light.
Warning message
Possible causes and remedies
On the video monitor
On the printer window display
(only for the UP-21MD)
HIT ANY KEY
HIT ANY KEY
This message appears when the remote control unit is used in
CAP-STOP (CAPTURE STOP) mode and when the printer
stops capturing images once images have been captured to all
memory pages (to the last point of the last memory page).
t
Press any button. Printer operation is enabled after this.
INPUT MISMATCH
INPUT MISMATCH
• The TV system of the signal input from the source
equipment (VTR, video camera and so on) is not
compatible with the TV system of your printer.
t
Check the signal of the TV system and input the
correct one.
t
Check the setting of the NTSC/PAL selector on the rear
panel. (See page 14)
• A signal other than a video signal (such as an audio signal,
etc.) is input.
t
Input the correct video signal.
NO INPUT
NO INPUT
• The printer is not receiving an input signal from
equipment corresponding to the input selected on the
INPUT SETUP menu.
t
Check the input signal selected on the INPUT SETUP
menu. (See page 20.)
t
Check whether the video equipment is outputting a
video signal in playback mode.
t
Check that the connections between the signal source
equipment and the printer are secure. (See page 14.)
NO IMAGE
NO IMAGE
The image is not captured in memory.
t
Capture the image in memory then start printing. (See
page 21.)
PRINTING MEMORY
PLEASE WAIT
NOW PRINTING
In the selected memory page, the captured image is being
printed or queued.
t
Retry the operation once the printer finishes printing.
HEAD IN COOLING
PLEASE WAIT
HEAD IN COOLING
The thermal head has overheated.
t
Leave the printer until the head cools down and this
message disappears. The printer starts printing
automatically.
