Installation and Operation Instructions for the following unitized outdoor camera models:
UNI-ONER / EP SERIES
Outdoor High PoE Clear Dome
UNI-ONER580C7
Unitized SNC-ER580 pendant type, clear dome, with heater and blower
UNI-ONER550C7
Unitized SNC-ER550 pendant type, clear dome, with heater and blower
UNI-ONER520C7
Unitized SNC-ER520 pendant type, clear dome, with heater and blower
UNI-ONEP580C7
Unitized SNC-EP580 pendant type, clear dome, with heater and blower
UNI-ONEP550C7
Unitized SNC-EP550 pendant type, clear dome, with heater and blower
UNI-ONEP520C7
Unitized SNC-EP520 pendant type, clear dome, with heater and blower
Note: To maximize power for the camera and heater option, the unit requires that you
calibrate the enclosure. This calibration process is shown starting with instruction
block 18. During calibration, the onboard processor intelligently determines the
maximum safe power output of the midspan, and ensures that the enclosure does
not exceed that limit. Once calibration is complete the required values are stored in
permanent memory, with no additional calibration required.
Note: Please note that to achieve the increased depth with the aspheric design for optimal
camera lens to capsule orientation, the capsule is slightly angled around the highest
section. This creates a ”line’, visible to the naked eye, around the upper most section
of the capsule. This “line” serves as the geometric center line used to insure proper
camera placement. It is not typically seen by the camera. However, this line maybe
visible in the camera image when camera’s above horizon tilt capability is used.
81-IN6712 06152012
