10
Adjusting the viewfinder position
The viewfinder position may be adjusted towards the front and
rear and to the left and right to make it easy to view.
To adjust the position to the left or right
1
Loosen the viewfinder left-right positioning ring.
2
Slide the viewfinder left or right to move it into a good
viewing position.
3
Tighten the viewfinder left-right positioning ring.
To adjust the position forward or backward
1
Loosen the viewfinder front-rear positioning lever.
2
Slide the viewfinder towards the front or rear of the
camera to move it into a good viewing position.
3
Tighten the viewfinder by rotating the front-rear
positioning lever.
Detaching the viewfinder
Loosen the viewfinder left-right positioning ring, pull the
viewfinder stopper, then pull out the viewfinder by sliding it in
the direction opposite to that when attached.
Attaching the Cable Clamp Belt
(Supplied)
You can secure the camera cable to the camera by attaching
the supplied cable clamp belt.
1
Insert the belt bracket into hole
A
or
B
of the cable
clamp belt.
2
Remove the protective seals shown in the figure
below.
3
Secure the cable clamp belt to the camera, using the
two suB3×8 screws.
4
1
Release the buckle,
2
bundle the cable with the
belt,
3
then lock the buckle again.
Viewfinder left-right
positioning ring
Viewfinder front-rear
positioning lever
A
B
Belt bracket
Protective seals
Screws (+B3×8)
