– 21 –
KV-EF29N6A/EF29N6B/EF29N9P
RM-882
2-5. TERMINAL BRACKET, PRINTED WIRING BOARD HOLDER,
DH BRACKET REMOVAL
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Don’t hurt the surface of anode-caps with shartp shaped
material!
2
Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
•
REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in
the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
b
.
a
b
c
Anode Button
5
Printed wiring board holder
4
Claw
6
Screw
(BVTP 3x12)
3
Terminal bracket
2
Screw
(BVTP 3x12)
7
DH bracket
1
Power cord
