SPA+B
(*)
:
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK/HEIGHT terminals (parallel connection).
(None):
[SPK OFF] appears on the display panel. No audio signals are output from any speaker
terminals.
Note
This setting is not available when headphones are connected.
When you press SPEAKERS on the receiver, the [Bluetooth Mode] changes to [Receiver]
automatically.
[153] Adjusting Settings
Performing Auto Calibration
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
To select [SPB] or [SPA+B], set the assignment for the SPEAKERS SURROUND BACK/HEIGHT terminals to
[Front B] by using [Surround Back Speaker Assign] in the [Speaker Settings] menu.
*
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Auto Calibration].
2
When you use height/overheard speakers, select [Change Surround Back Speaker
Assign], and then select [Height Speakers] on the next screen.
3
Select [Proceed to configure the speaker pattern], and then set the speaker pattern
on the next screen.
If you have set [Height/Overhead Speakers] to a value other than [FH] or [---], set [Ceiling
Height] on the next screen.
4
Make sure that the calibration microphone is connected to the receiver, and then
select [Proceed to the next step].
5
Confirm the instructions on the screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process takes approximately 30 seconds. A test tone is output from
each speaker in sequence.
When the measurement ends, a beep sounds and the screen switches.
6
