22
Operations Using the Supplied Infrared
Remote Commander
Before Starting Operations
Before operating, check that the camera and
peripheral devices are properly installed and
connected.
For details, see “Installing the Camera” (page 14)
and “Connecting the Camera” (page 17).
Turning on the Power
1
Connect the camera to an AC outlet using
the supplied AC adapter and power cord.
Or, connect the powered PoE+ power supply
device and the camera with a LAN cable.
The power is turned on and the POWER lamp
turns green.
When the power is turned on, the camera
will automatically pan and tilt (pan/tilt reset),
and then stops at the position stored as
PRESET 1.
2
Turn on the peripheral devices.
If the POWER button on the remote
commander is pressed while the camera is
turned on, the camera goes into the standby
mode. The POWER lamp turns off and the
STANDBY lamp turns on.
Note
Wait at least 10 seconds if you want to turn on the
camera again after putting it in the standby
mode.
Operating Multiple Cameras
Using the Infrared Remote
Commander
1
Set the IR SELECT switch on the back of the
camera you want to operate to 1, 2, or 3.
2
Press the CAMERA SELECT button on the
remote commander that corresponds to the
number set in step 1.
You can then operate the specified camera(s).
Every time you operate the camera(s) using the
remote commander, the CAMERA SELECT button
pressed in step 2 lights up.
POWER lights
To the AC adapter (supplied)
CAMERA SELECT