Sony SLV-SE610K, Operating Instructions Manual

Page: 13 / 100

Getti
ng Sta
rted
13
Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
* SLV-SE810N/K only
Controlling other TVs with the remote commander
(SLV-SE810N/K only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the following table, set the appropriate manufacturer’s code
number.
* These buttons may not work with all TVs.
Adjust the volume of the TV
2
+/–
Switch to TV (Teletext off)*
a
(TV)
Switch to Teletext*
/
(Teletext)
Select the sound AUDIO MONITOR
Use FASTEXT* FASTEXT buttons
Call up the on-screen display
DISPLAY
Change the Teletext page*
c
/
C
Switch to/from wide mode of a Sony wide TV (For
other manufactures’ wide TVs, see “Controlling
other TVs with the remote commander (SLV-
SE810N/K only)” below.) WIDE
1
Set
[TV]
/
[VIDEO]
at the top of the remote commander to
[TV]
.
2
Hold down
?
/
1
, and enter your TV’s code number using the programme
number buttons. Then release
?
/
1
.
Now you can use the following TV control buttons to control your TV:
?
/
1
,
t
TV/VIDEO, programme number buttons,
-
(ten’s digit),
PROG +/–,
2
+/–,
a
(TV),
/
(Teletext), FASTEXT buttons, WIDE*,
MENU*,
M
/
m
/
<
/
,
*, and OK*.
To Press
continued