46
Recording TV programmes
To save a recording
To prevent accidental erasure, break off the safety
tab as illustrated. To record on the same tape
again, cover the tab hole with adhesive tape.
Tips
• To select a programme position, you can use the programme number buttons on the remote
commander. For two-digit numbers, press the
-
(ten’s digit) button followed by the
programme number buttons.
• If you connect additional equipment to a LINE connector or jack, you can select the input
signal using the INPUT SELECT or PROG +/– buttons.
• The
DISPLAY information appears on the TV screen indicating information about the
tape, but the information won’t be recorded on the tape.
• If you don’t want to watch TV while recording, you can turn off the TV. When using a
decoder, make sure to leave it on.
Notes
• The
DISPLAY information does not appear during still (pause) mode or slow-motion
playback.
• The
DISPLAY information will not appear while playing an NTSC*
3
-recorded tape.
• If a tape has portions recorded in both PAL and NTSC*
3
systems, the time counter reading
will not be correct. This discrepancy is due to the difference between the counting cycles of
the two video systems.
• You cannot watch a PAY-TV/Canal Plus programme while recording another PAY-TV/Canal
Plus programme.*
2
• When you insert a non-standard commercially available tape, the remaining time may not be
correct.
• The remaining time is intended for rough measurement only.
• About 30 seconds after the tape begins playback, the tape remaining time will be displayed.
• The station name*
1
may not appear if the VCR does not receive station name information
signals.
*
1
not available on SLV-SE100A1/A2
*
2
not available on SLV-SE100A1/A2 and SE200V1/V2
*
3
SLV-SE100A1/A2 cannot play NTSC-recorded tapes.
Safety tab
