Sony SLV-E120AE, Service Manual

Page: 24 / 69

5-9
3-3-2. CASSETTE DRIVE GEAR (See Fig. 3-3-3)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove clamps
1
and
2
, then remove the gear holder
3
.
3) Remove the clamp
1
, then remove the pinion gear
4
.
4) Remove the clamp
2
, then remove the lockgear
5
.
ASSEMBLY NOTES:
1. Put the tray in the EJECT mode position before fitting
any parts.
2. Apply grease (VHJ-0100) to the gear mounting shafts,
all the gear teeth, and the cam part of the drive gear
6
.
3. Ensure that the drive gear, the lock gear and the pinion
gear interlock correctly, as shown in Fig. 3-3-2.
4. Make sure the clamps
1
and
2
snap in to the gear
holder
3
.
Tray
6
Drive gear
5
Lock gear
(grease the outer rim
of the teeth)
3
Gear holder
2
Clamp
1
Clamp
Apply
grease
4
Pinion gear
(grease
the outer rim
of the teeth)
Fig.3-3-3
3-3-3. DOOR OPENER, UNDER FRAME AND
STAND L (See Fig. 3-3-4)
1) Remove the cassette mechanism assembly, referring to
section 3-1.
2) Remove the two clamps
1
and take out the under
frame
2
, pulling it towards you.
3) Press down the tray lock lever
3
and the lid opener
lever
4
, and loosen the tray
5
, lifting it away from you.
In this state, press the clamp
6
and remove the door
opener lever
7
.
4) Remove the two clamps
8
and take out the stand L
9
.
Be careful not to exert too much force on the clamps
8
,
as this could cause damage.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the grooves
!¡
on the
stand L, the inside of the hole
!£
in the drive shaft
!™
.
and the mounting hole
!¢
in the door opener lever of
the stand R.
2. Before fitting the stand L
9
, be sure to move the tray
5
back as far as the EJECT mode position. Put the two
pins
0
on the tray
5
into the grooves
!¡
on the stand
L. Put the drive shaft
!™
into the hole
!£
.
3. Be suretofasten the two clamps
1
and theclamp
6
on
the stand R, and to fasten the two clamps
8
on the
stand L.
9
Stand L
!¡
Grooves
!£
Hole
0
Pins
1
Clamp
1
Clamp
!™
Drive
shaft
3
Tray
lock lever
5
Tray
6
Clamp
7
Door opener
lever
2
Under frame
!¢
Hole
4
Lid opener
lever
8
Clamps
Stand R
Fig.3-3-4