Sony SCD-XB770, Operating Instructions Manual

Page: 21 / 112

Playing Discs
21
GB
Creating Your Own
Programme
(Programme Play)
Z
You can pick out the tracks that you like and specify the
playback order in a programme containing up to 32
tracks (or 999 min. 59 sec. in total programme time)
1
Press PROGRAM in stop mode.
“PROGRAM” appears in the display.
2
Press the number buttons to enter the track
number.
If you entered the wrong track number
Press CLEAR to erase the track number and reenter
the correct track number using the number buttons.
To select a track number over 11
Press >10 (page 18).
3
Repeat step 2 to enter other tracks.
Each time you enter a track number, the total
programme time appears in the display.
4
Press H .
Programme Play starts.
To resume normal play
Press CONTINUE.
z
The programme remains even after Programme Play ends
Press H to play from the beginning of the programme again.
The programme remains even if you stop play.
Note
If you turn off the player, disconnect the mains lead, or press
A OPEN/CLOSE, the programme will be erased.
CLEAR
CONTINUE
Number
buttons
H
>10
PROGRAM
CHECK
. / >
Checking the contents of the programme
Before you start playing or while the player is playing,
press CHECK.
Each time you press the button, the track numbers will
appear in the display in the programmed order.
When you press CHECK while the player is playing, the
track number appears from the next track numbers of the
current playing track number.
Changing the contents of the programme
You can change the contents of the programme in stop
mode.
To
Erase a track
Erase from the last
track in the
programme
Add a track to the
end of the
programme
Erase all tracks
Do the following:
1
Press CHECK repeatedly until the track
number you want to erase appears.
2 Press CLEAR.
Press CLEAR.
Each time you press the button, the last
track of the programme is erased.
Press . / > to select the track you want
to add, then press PROGRAM. When using
the remote, press the number button of the
track to be added.
Hold down CLEAR or x (for about 2
seconds) until ”Prog CLEAR“ appears in
the display.