37
GB
To clear the “learned” remote
control signal
While holding S (set)
pressed, press one of the
SYSTEM CONTROL 1, 2 or
3 button.
The S (set) indicator and all
Component Select buttons light
up when you press these
buttons, and turn off when you
release them.
Notes on the “learned”
signals of an air-
conditioner
About seasonal adjustments
If you change the settings of the
air-conditioner for the season, you
have to program the remote
control signals of the new settings
on the Commander.
If the power-on/off operation
does not work correctly
The air-conditioner may not be
turned on or off properly with the
button of this Commander to
which you have programmed its
power-on/off signal.
If the Commander can operate
only “ON” with one button and
“OFF” with another, while your
air-conditioner’s remote control
can operate “ON/OFF” with a
single button, program the signal
on two buttons of the Commander
as follows.
1
Clear the “learned” power-on/
off signal.
(In the example on page 35,
clear the “learned” signal from
the SYSTEM CONTROL 2
button.)
2
Program the signal (transmitted
from the power-on/off button
of the air-conditioner’s remote
control) for the SYSTEM
CONTROL 2 button again.
3
Program the signal from the
same button of the remote
control for another button (for
example, the SYSTEM
CONTROL 3 button).
The two buttons of the
Commander have been
programmed with the power-on
signal and the power-off signal of
the air-conditioner respectively, so
that you can operate the air-
conditioner with the Commander.
