2-15. Connector Box Section
2-15-1. Connector Box Assembly
Preparation
1.
Remove the outside panel assembly. (Refer to
2.
Remove the bracket (WA) assembly.(Refer to
“2-6. Wi-Fi Module/SD-58 Board”
3.
Remove the inside panel assembly. (Refer to
“2-3-1. Inside Panel Assembly”
)
4.
Remove the DCP-67 board. (Refer to
5.
Remove the HPR-53 board. (Refer to
6.
Remove the DPR-362 board. (Refer to
)
7.
Remove the EC-82 board. (Refer to
8.
Remove the duct box assembly . (Refer to
Procedure
1.
Disconnect the harnesses.
1) Disconnect the two harnesses from the two connectors (CN100, CN101) on the RE-326 board.
2) Remove the Tape 50.
CN101
(RE-326 board)
CN100
(RE-326 board)
Tape 50
Harnesses
Note
When installing the tape 50, install it at the location as shown in the following figure.
Note
When connecting the harnesses, arrange the harnesses as shown in the following figure.
Battery harness
Tape 50
About 30mm
About 25mm
DC-IN harness
Battery harness
PXW-X500
2-59
Summary of Contents for PXW-X500
