Changing the “Monitor Output” and
“Frequency” Settings with the Remote
Commander
If the “Monitor Output” and “Frequency” settings in the Video setup menu are configured incorrectly, pictures
will not be displayed on the monitor. In such cases, use the
(power) switch on the Communication System
and the buttons on the Remote Commander to configure the correct settings.
To change the “Monitor Output” setting
After verifying that the
(power) switch indicator on the system is lit, perform the following.
Press the
(power) switch on the Communication System.
Within five seconds after you pressed the
switch, press the buttons on the
Remote Commander as follows, based on the desired “Monitor Output.”
Desired “Monitor Output”
On the Remote Commander, press:
HDMI 1
VIDEO INPUT button (once)
Number button 3 (three times)
DVI-I OUT
VIDEO INPUT button (once)
Number button 4 (three times)
The “Monitor Output” setting is changed, and the picture appears on the monitor connected to the system.
To change the “Frequency” setting
After rebooting the system and verifying that the
(power) switch indicator changes from blinking to
remaining steadily lit, perform the following.
Press the
(power) switch on the Communication System.
Within five seconds after you pressed the
switch, press the buttons on the
Remote Commander as follows, based on the desired “Frequency.”
Desired “Frequency”
On the Remote Commander, press:
60 Hz
VIDEO INPUT button (once)
Number button 1 (three times)
50 Hz
VIDEO INPUT button (once)
Number button 2 (three times)
The “Frequency” setting is changed, and the system reboots.
Note
The Remote Commander cannot be paired with cameras.
“IPELA” and
are trademarks of Sony Corporation.