Sony MVS-8000X System, User Manual

Page: 68 / 1310

Ch
apt
er 2
Me
nu
s
an
d Cont
rol P
ane
l
68
Names and Functions of Parts of the Control Panel
EMBOS (emboss): Apply an embossing
effect to the periphery of the key.
• To select a “normal” as the edge type
(that is, a plain edge), set all five of the
above buttons off.
• When border, drop border, or shadow is
selected, you can use a special color
matte or a signal selected on the utility 1
bus for the edge.
• When emboss is selected, you can use the
dedicated color matte signal for the
emboss function.
• When outline is selected, the signal
selected on the key fill bus is used to fill
the edge.
MAIN MASK: Press this button, turning it
on, to enable the key mask using the
main pattern. It also enables you to set
the parameters with the knobs.
SUB MASK: Press this button, turning it
on, to enable the key mask using the
sub pattern. It also enables you to set
the parameters with the knobs.
ZABTN (zabton): When this is pressed,
turning it on, a translucent pattern is
inserted behind the key. With the
knobs, you can adjust the color, size,
density, and softness parameters.
SOFT EDGE: Soften the edge of the key.
e
MORE button
When there are more than four parameters,
this button lights amber. When it is pressed,
it changes from amber to green and the fifth
and subsequent parameters are assigned to
the knobs, allowing them to be adjusted.
f
SHOW KEY button
While this button is held down, a key
processed key source signal is output from
the specified output port. You can make the
output specification independently for each
of edit preview and the preview of each M/
E or PGM/PST bank in a Setup menu.
g
Knobs
Turn the knobs to adjust the parameter
values.
h
Displays
Each display shows the initial letters of the
parameter name and the parameter value
(maximum three digits including a minus
sign for a negative value).
i
DME channel selection buttons
Press one of these buttons, turning it on, to
delegate a DME channel to the keyer.
The number of valid DME channel
selection buttons depends on the number of
channels installed in the DME processor.
A maximum of four consecutively
numbered DME channels from the two sets,
DME 1 to 4 and DME 5 to 8, can be
assigned to one keyer.
When the signal format is 1080P only, the
consecutive channel combinations that can
be selected are any of DME1 and DME2,
DME3 and DME4, DME5 and DME6, or
DME7 and DME8.
DME channel assigned to a keyer cannot
be selected on another keyer.
However, using the override function it is
possible to allocate a channel already
allocated to another keyer to the currently
selected keyer. If DME channel allocations
have been made in a Setup menu, these
buttons cannot be used to make DME
channel allocations. Using the trace
function, it is possible to check which keyer
a DME channel is allocated to.
j
ON AIR indicators
These light red when the corresponding
DME channels are included in the final
program output.
k
Output destination specification
buttons
MON (DME monitor): Hold down this
button and press the selection button