Sony MVS-8000X System, User Manual

Page: 62 / 1310

Ch
apt
er 2
Me
nu
s
an
d Cont
rol P
ane
l
62
Names and Functions of Parts of the Control Panel
h
Key status display
For each of the next transition selection
buttons, [KEY1] to [KEY4], the
corresponding ON indicator lights when the
key is inserted. It also shows the priority (1
to 4) of each key.
i
PRIOR (priority) SET button
While this button is held down, you can set
the key priority.
The setting mode when this button is
pressed depends on whether or not the
[KEY PRIOR] button is lit, as follows.
• When the [KEY PRIOR] button is off, the
current key priority is set.
• When the [KEY PRIOR] button is lit, the
key priority after the next transition is set.
Press the [KEY PRIOR] button as required,
to switch between these two modes.
In either mode, hold down the [PRIOR
SET] button, and press the button ([KEY1]
to [KEY8]) corresponding to the key you
want to bring to the front.
Notes
The key priority establishes a separate
priority order within each of the groups of
keys 1 to 4 and keys 5 to 8. You can make
any setting within the groups of keys 1 to 4
or keys 5 to 8, but not for combinations of
keys from different groups. For example, it
is not possible to set a priority sequence of
keys 1, 5, and 2.
For details, see “Setting the Key Priority in
the Transition Control Block” (page 163).
The following controls are used as the
independent key transition control block.
j
Key delegation buttons
These buttons delegate this independent
key transition control block to a desired
keyer. Press one of the [KEY1] to [KEY8]
buttons ([DSK1] to [DSK8] in the PGM/
PST bank), turning it on.
You can press more than one button to
select two or more keyers.
While these buttons are held down, you can
select a key source with the cross-point
buttons for the key bus.
Pressing one of these buttons twice in rapid
succession changes its state so that you can
make cross-point selections on the
corresponding key bus.
For details of assignment of keys 5 to 8, see
“Assigning Buttons for Selection of Keys 5
to 8 in the Setup Menu” (page 544) in
Appendix (Volume 1).
k
Independent key transition type
selection buttons
Press one of the following buttons, turning
it on, to select the independent key
transition type.
You can assign any transition types to these
buttons in setup (
see “Overall Control
Panel Settings (Config Menu)” in Chapter
19 (Volume 3)
).
MIX: Faded in or out.
WIPE: Inserted or deleted with a wipe.
DME (DME wipe): Inserted or deleted
with a DME wipe.
CUT: Instantaneously insert or remove the
key selected with the delegation
buttons.
l
Independent key transition
execution section
KEY1 ON to KEY8 ON (DSK1 ON to
DSK8 ON in the PGM/PST bank)
buttons:
Press the corresponding one
of these buttons to cut key 1 to key 8 in
or out instantaneously. When the key
corresponding to the button appears in
the final program output, the button
lights red, and otherwise lights amber.
AUTO TRANS (transition) buttons:
These correspond to keys 1 to 8 from
left to right; press one to carry out an
auto transition. The transition rate for