13
Various Playback
This chapter describes various functions for
playback.
Playing a disc
ENTER
SEARCH
POWER
DISPLAY
CLEAR
SETUP
AUDIO
ANGLE
SUBTITLE
MENU
TOP MENU
INPUT
1
2
3
4
5
6
7
8
9
0
VOL
./>
u
x
POWER
SEARCH
M/m
</,
/y
m/M
VOL
1
Open the monitor and adjust the tilt and
swivel.
2
Press
(POWER)
to turn on the player.
The monitor turns on and the green light of
the POWER switch on the player lights up.
Number
buttons
3
Insert the disc (labeled side up) into the
player.
Playback starts automatically.
If a disc is already inserted or playback does
not start automatically, press
u
to start
playback.
4
Press
(VOL)
(+) or
(VOL)
(–) on the card
remote commander to adjust the
volume.
To turn off the power
Press
(POWER)
so that the green light of the
POWER switch on the player turns off.
After use
Turn off the player and disconnect the power
cord from the power source.
Note on using the player in the car
Using the player while the ignition key is in
ACC position and the engine is stopped may
cause the car battery to run down.
Notes
• Even when the player is turned off, you can eject
a disc from the player, though you cannot insert
a disc.
• Read the instruction manual supplied with the
disc to play with this player.
• When you play an 8-cm disc (e.g., CD-single), be
sure to insert it to the center area of the disc slot.
• Depending on the recording method used on the
disc, it may take a minute or more before
playing.
• Depending on the condition of the disc, it may
not play back (page 32).
• A high-bit rate MP3 file such as 320 kbps may not
play back properly.
continue to next page
t
