Sony MPE-200, Installation Manual

Page: 17 / 26

1-9 (E)
MPE-200
2. KY-660 board
<Switch >
Ref No. Address Name Function Factory setting
S102 (A-2) _ S102-1: Bank switching of NOR flash memory All OFF
ON: Backup
OFF: Main
S102-2: Sets the starting mode.
ON: Automatically starts when the AC
power turns on.
OFF: Does not start automatically.
S102-3: Sets the starting path.
ON: Forcibly starts in the maintenance mode.
OFF: Starts with the path set on the firmware.
S102-4 to 6: Not used
S102-7, 8: Sets the RS-232C function
* 1
* 1: Setting the RS-232C function
S102-7 S102-8 Front side RS-232C
* * * * * 2
Rear side RS-232C
OFF OFF Not used Console/System control mode
ON OFF Console mode System control mode
OFF ON Console/System control mode Not used
ON ON Not used Not used
* 2: The RS-232C connector of the front side is on the KY-660 board. When using it, the front panel must be removed.
(For the procedure to remove the front panel, refer to “2-2-1. Cleaning”.)
1 2 3 4 5 6 7 8
( indicates the knob position.)
S102
D107
D108
D109
D110
D111
A B C
1
2
Side A
CN202
RS-232C