56
• When using CDs that have glue or similar tacky
substance on the label side of the disc or that used
a special ink when the label was printed, there is a
chance that the CD or label may become attached
to parts inside this unit. When this occurs, it may
not be possible to remove the CD, and may also
cause this unit to malfunction. Be sure to check
that the label side of the CD is not sticky before
using.
The following types of CD should not be used:
— Rental or used CDs with attached seals where
the glue extends beyond the seal. The
perimeter of the seal on the CD is tacky.
— CDs that have labels printed using a special
ink that feels tacky when touched.
Cleaning the cabinet
Use a soft cloth slightly moistened with mild
detergent solution.
To remove the speaker grille
Use both hands and pull the grille straight forward
to prevent the ribs from breaking.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
Additional Information
Precautions
On operating voltage
Before operating the system, check that the
operating voltage of your system is identical with
the voltage of your local power supply.
On safety
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet, even if the unit itself has been turned
off.
• Unplug the system from the wall outlet (mains) if
it is not to be used for an extended period of time.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
component, unplug the system and have the
component checked by qualified personnel before
operating it any further.
• The mains lead must be changed only at a
qualified service shop.
On placement
• Place the system in a location with adequate
ventilation to prevent heat build-up in the system.
• Do not place the unit in an inclined position.
• Do not place the unit in locations where it is:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Vibrating
— Subject to direct sunlight.
On operation
• If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.
• When you move the system, take out any discs.
If you have any questions or problems concerning
your system, please consult your nearest Sony
dealer.
Notes on CDs
• Before playing, clean the CD with a cleaning cloth.
Wipe the CD from the centre out.
• Do not use solvents such as benzene, thinner,
commercially available cleaners or anti-static
spray intended for vinyl LPs.
• Do not expose the CD to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.
Tab of side B
Tab of side A
Detector slots
Side A
Break off the
cassette tab of
side A
If you later want to reuse the tape for recording,
cover the broken tab with adhesive tape. However,
be careful not to cover the detector slots which allow
the tape player to automatically detect the type of
tape.
Tape type:
CrO
2
/METAL NORMAL
Detector slots
