58
Automatic tuning is not possible.
Setting of the local seek mode is not correct.
– Tuning stops too frequently:
Set “LOCAL-ON” (page 48).
– Tuning does not stop at a station:
Set “LOCAL-OFF” (page 48).
The broadcast signal is too weak.
– Perform manual tuning.
During FM reception, the “ST” indication
flashes.
Tune in the frequency accurately.
The broadcast signal is too weak.
– Set “MONO-ON” (page 48).
An FM program broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
– Set “MONO-OFF” (page 48).
RDS
PTY displays “- - - - - - - -.”
The current station is not an RDS station.
RDS data has not been received.
The station does not specify the program type.
Picture
There is no picture/picture noise occurs.
A connection has not been made correctly.
Check the connection to the connected
equipment, and set the input selector of the
equipment to the source corresponding to this
unit.
Defective or dirty disc.
Installation is not correct.
– Install the unit at an angle of less than 45° in
a sturdy part of the car.
The monitor is connected to the AUDIO/
VIDEO OUT, and the parking cord (light
green) is not connected to the parking brake
switch cord, or the parking brake is not
applied.
The color system setting is incorrect.
– Set the color system to “PAL” or “NTSC”
according to the connected monitor
(page 46).
Picture does not fit in the screen.
The aspect ratio is fixed on the DVD.
Sound
There is no sound/sound skips/sound cracks.
A connection has not been made correctly.
Check the connection to the connected
equipment, and set the input selector of the
equipment to the source corresponding to this
unit.
Defective or dirty disc.
Installation is not correct.
– Install the unit at an angle of less than 45° in
a sturdy part of the car.
The MP3 file sampling rate is not 32, 44.1, or
48 kHz.
The WMA file sampling rate is not 32, 44.1, or
48 kHz.
The AAC file sampling rate is not 44.1, or 48
kHz.
The MP3 file bit rate is not 48 to 192 kbps.
The WMA file bit rate is not 64 to 192 kbps.
The AAC file bit rate is not 40 to 320 kbps.
The unit is in pause/reverse/fast-forward
mode.
The settings for the outputs are not made
correctly.
The DVD output level is too low (page 27).
The volume is too low.
The ATT function is activated, or the
Telephone ATT function (when the interface
cable of a car telephone is connected to the
ATT lead) is activated.
The position of the fader control “FAD” is not
set for a 2-speaker system.
Unsupported format (such as DTS).
– Check if the format is supported by this unit
(page 7).
Sound is noisy.
Keep cords and cables away from each other.
Disc operation
The disc cannot be loaded.
Another disc is already loaded.
The disc has been forcibly inserted upside
down or in the wrong way.
The disc does not play back.
Defective or dirty disc.
The disc is not applicable.
