- 14 -
2-6. Service Position
Position the chassis as indicated to access the solder side
of the PWB’s. To gain access to the A Board follow the
instructions on page 16. [Removal and Replacement of the
main bracket bottom plates ].
2-4. Side Control Module Removal
Remove the two screws fixing the user control module to the
side of the set. The control module can then be removed by
sliding it towards the rear of the set allowing access to the H2
Board.
2-5. H2 Board Removal
2
To remove the H2 board release the two clips circled and ease
the board gently away from the support bracket.
2-7. Wire Dressing
Ensure that wires do not touch heatsinks and high temperature
hotspots. All wires must be kept at a minimum distance of
20mm away from the EHT lead
Screws
Clips
20mm
20mm
