– 43 –
KP-41PX1/41PX1K/41PX1R
K
RM-892
RM-892
RM-862
RED REGISTRATION ADJUSTMENT
1. Receive the Internal pattern (crosshatch) signal.
GH GSEL = “00” (Green + Red)
2. Adjust so that the red lines lay on the green lines.
Adjust, using the same procedure as the green sub item
adjustment outline above.
Note : Main registration correction should not be while
adjusting Red adjustment.
BEWARE : Not to change green sub items.
It’ s easily done by mistake.
BLUE ADJUSTMENT
1. Receive the Internal pattern (crosshatch) signal.
BH BSEL = “00” (Blue + Green)
2. Adjust so that the blue lines lay on the green lines.
Adjust, using the same procedure as the green sub item
adjustment outline above.
Note : Main registration correction should not be while
adjusting Blue adjustment.
BEWARE : Not to change green and red sub items.
It’ s easily done by mistake.
REGISTRATION DATA WRITE
1. After finish all PAL registration adjustments, write PAL reg-
istration data by pressing form the appropriate buttons.
DATA WRITE : Press “
(MUTE)” + “
-
”
DATA COPY FROM PAL TO NTSC
1. Copy PAL data to NTSC data by pressing form the appropri-
ate buttons.
DATA COPY
: Press “
(ON SCREEN DISPLAY)”
+ “
-
”
2. Press “
” + “
-
” to copy data from PAL to NTSC.
If you press “
” ,then it appears “Copy 5060” to display.
∗
Make sure input signal is PAL. If input signal is NTSC
and do this process, NTSC data are copied to PAL data !
4 : 3 MODE ADJUSTMENT
1. Receive the PAL SPCB signal.
2. Select 4 : 3 mode.
Press “
(blue key)” : 16 : 9
b
4 : 3
3. 4 : 3 mode adjustment are the same as 16 : 9 mode.
AUTO CONVERGENCE PRESET
1. Set in the TT mode.
2. Press “
(AUTO CONVERGENCE)” button on front
panel.
3. Confirm convergence is the same condition as before.
4. Press “
-
” + “
-
” button on commander to exit from the TT
mode.
TT00 : Exit from the TT mode
6-3. HORIZONTAL POSITION ADJUSTMENT
1. Receive the PAL SPCB signal.
2. Select 4 : 3 mode.
Press “
(blue key)” : 16 : 9
b
4 : 3
3. Set in the service mode and select “Geometry” .
4. Adjust “H position” so that the picture is displayed in the
horizontal center of screen.
6-4. TEXT POSITION ADJUSTMENT
1. Receive the RF signal with teletext.
Signal must have burst. Select full page text.
2. Set in the TT mode.
3. Press “
1
” + “
4
” (41PX1/41PX1K) or “
7
” + “
4
” (41PX1R)
button on commander.
TT14 : TEXT H POSITION adjustment (41PX1/41PX1K)
TT74 : TEXT H POSITION adjustment (41PX1R)
4. Adjust H position of text.
5. Push “
(TV MODE)” to exit.
A
B
A = B
With the joystick
:
b
(Move the Left)
B
(Move the Right)
