Sony KD-32NX200E, Instruction Manual

Page: 7 / 120

Getting started
5
Connecting an aerial and a VCR to the TV
Connecting an aerial and a VCR
Switching on the TV
Connecting an aerial only
3
4
1. Connect your existing aerial lead to the digital
socket marked
on the rear of the TV as
shown.
2.
Connect the supplied RF loopthrough cable from
the socket marked
to the analogue socket
marked .
1. Connect your existing aerial lead to the digital
socket marked
on the rear of the TV as shown.
2. Connect the supplied RF loopthrough cable from
the lower socket marked
on the TV to the RF
IN socket on your VCR.
3.
Connect a lead from the RF OUT socket on your
VCR to the analogue socket marked
on the TV.
4.
Connect a fully wired scart lead from the
socket on the rear of the TV to the scart
socket on your VCR (refer to your VCR instruction
manual).
5.
Connect the VCR to the mains socket and switch
on.
6.
Insert a pre-recorded tape into the VCR and press
the ‘PLAY’ button. This enables the TV to locate and
store the video channel during the ‘Automatically
tuning the TV’ procedure.
Note:
Your VCR sockets may not be labelled RF IN and RF OUT. If not,
please refer to your VCR instruction manual for guidance.
s
3 3
1.
Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz).
2.
Push in the on/off button (labelled ) on the
front of the TV.
Note:
If the red indicator on the front of the TV is lit the TV is in standby
mode. Press the TV
button on the remote control to switch on
the TV. Please be patient as the picture may take a few moments to
appear on screen.
/
R/D/D/D L/G/S/I
ANALOGUE
1
2
DVD
VCR
s 3 3
(SMARTLINK)
DIGITAL
OPTICAL OUTPUT
MODEM . . . 5V 200mA
Existing
aerial lead
R/D/D/D L/G/S/I
ANALOGUE
1
2
DVD
VCR
s 3 3
(SMARTLINK)
DIGITAL
OPTICAL OUTPUT
MODEM . . . 5V 200mA
RF loopthrough
cable (supplied)
RF lead (not
supplied)
Scart lead
(not supplied)
RF loopthrough
lead (supplied)
GBpages1-8.fm Page 5 Tuesday, October 15, 2002 10:23 AM