10
6
Attach the camera unit to the bracket with the camera
unit mounting screws (four screws).
Tighten the four mounting screws attached to the unit, and
fix the camera unit to the bracket.
Note
Water may enter if not attached properly.
Installing the Camera (if you use a
commercially available LAN cable)
1
Perform the steps 1 to 3 of “Installing the Camera”
(page 9).
2
Adjust the LAN cable to the camera unit.
Attach the LAN cable with the sealing rubber to the hole
with the
mark of the camera unit.
3
Perform the steps 5 to 6 of “Installing the Camera”
(page 9).
4
Cut the cable to a proper length and attach the network
connector at the end of the cable.
5
Connect the cable to the network port.
Note
Water may enter if not attached properly.
Installing the Camera (If you use the
conduit hole on the side)
1
Perform the steps 1 to 3 of “Installing the Camera”
(page 9).
2
Wire the cables on the bottom.
1
Insert the cables to the pipe and conduit hole.
2
Wire the cables.
3
Insert the pipe to the conduit hole.
3
Perform the steps 5 to 6 of “Installing the Camera”
(page 9).
Note
When using a flanged pipe or cable gland, refer to
“Important precautions” (page 12).
Installing the Camera (if you use a
multi connector cable)
1
Perform the steps 1 to 3 of “Installing the Camera”
(page 9).
2
Wire the cables on the bottom.
Wire the supplied LAN cable or multi connector cable as
required.
3
Perform the steps 5 to 6 of “Installing the Camera”
(page 9).
Adjustment of the Shooting
Direction and Range
You can adjust the directions of pan, tilt, and rotation.
There is no fixed screw for the pan and rotation directions.
f
TOP mark indicates the upper direction of the image.
You can invert the image by using the setting menu.
Press the sealing rubber.
f
TOP
mark
Pan
Tilt
Rotation
Tilt fixing
screw
