Chapter 3
Dubbing/Editing
41
Chapter
3
Dubbing/Editing
Dubbing to Other Equipment
This section describes the connections and settings
necessary to perform dubbing on other equipment, using
the unit as a video player.
To digital video equipment with an i.LINK
jack
Connect the unit to the recorder as shown on the right
using an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and output.
Also, by connecting the unit to an editing controller via
the HDV/DV jack, you can configure a digital non-
linear editing system.
For connections of the editing controller and the unit, refer to
the editing controller instruction manual.
Before dubbing, you must set the format in which you
want to output signals. Make [HDV/DV SEL]
settings in the [IN/OUT
REC] menu.
For details, refer to “Major Differences among HDV1080i,
DVCAM, and DV Formats” on page 24 .
For details on i.LINK output formats, see page 72.
To dub a tape recorded in HDV format using the
duplicate function on other units such as the DSR-25/
45/50, select [DVCAM] in [HDV
t
DV CONV] of
[i.LINK SET] in the [IN/OUT REC] menu.
There are some limitations to down converting a tape
recorded in HDV format to DVCAM format.
For details, see “i.LINK SET” in the “IN/OUT REC” menu
on page 51.
Connections for Dubbing
HVR-M15A (rear panel)
Monitor
i.LINK cable (not supplied)
To i.LINK jack
Digital video equipment
with an i.LINK jack
: Signal flow
Monitor
(Continued)
