HT-ST9
8
6. Select “Reset to Factory Default Settings”, and press the [ ]
button on the remote commander.
Setup
Reset to Factory Default Settings
Restor each setting to the factory setting.
Initialize Personal Information
7. Press the [
V
]/[
v
] buttons on the remote commander to select
the “All Settings”, and press the [ ] button on the remote com-
mander.
Reset to Factory Default Settings
Audio Settings
Bluetooth Settings
System Settings
Input Skip Settings
Network Settings
All Settings
8. Press the [
B
]/[
b
] buttons on the remote commander to select
the “Start”, and press the [ ] button on the remote commander.
All Settings
Restore all settings to the factory default
settings. The system will turn off after
reset.
Start
Cancel
9. Turn the power off automatically, and initialization ends.
NOTICE OF MAC ADDRESS CHANGE TO CUSTOM-
ERS
When the MB1406 board or card WLAN/BT combo is replaced,
the MAC address has been changed.
Print the following explanations, and pass it to the customer with
the repaired unit when you return the customer repaired unit.
Note of the MAC address change:
The MAC address of this unit was changed along with this repair.
Please set it again if you are using the MAC address
fi
ltering function
of access point device of connection destination.
MAC address can be con
fi
rmed from the settings menu screen of this
unit. Please refer to the “Settings and Adjustment” of Operating In-
structions for details.
NOTES ON THE WIRELESS CONNECTION (LINK) AF-
TER REPAIRS ARE COMPLETE
When the following replacing repair is performed, the link of the
Bar speaker (SA-ST9) and Subwoofer (SA-WST9) is cut.
Return the Bar speaker (SA-ST9) and Subwoofer (SA-WST9) to
the customer after performing the link according to the following
procedure.
Parts in which the LINK will be disconnected due to replacement:
• Complete MB1406 board
Link method:
When you turn on the Bar speaker (SA-ST9) and Subwoofer (SA-
WST9), and then automatically link.
If do not to link, there is a possibility that the customer is perform
the secure link. In that case, perform the following procedure.
Procedure of secure link:
1
Select [Wireless Sound Connection] in [System Settings]
2
Select [Secure Link].
3
Select [On].
4
Press SECURE LINK on the rear of the subwoofer.
Proceed to the next step within a few minutes.
5
Select [Start].
To return to the previous display, select [Cancel].
6
After the message [Secure Link setting is complete.] appears,
press .
The on/standby indicator on the subwoofer lights in orange.
If the message [Cannot set Secure Link.] appears, follow the on-
screen instructions.
Note:
If customer had perform a secure link, only the Bar speaker is
brought in for repair and the MB1406 board is replaced, be sure to
inform the customer when returning the repaired products that the
customer must secure link again the Bar speaker and Subwoofer.
(Indicate that the secure link procedure is described in the operating
instructions)
“PRTCT,” “PUSH” AND “POWER” FLASH ALTER-
NATELY IN THE FRONT PANEL DISPLAY
Press
(on/standby) to turn off the system. After the indicator
disappears, disconnect the AC power cord (mains lead) and make
sure nothing is obstructing the ventilation holes of the system.
