Sony HKSP-1125, Installation Manual

Page: 18 / 26

16 (E)
HKSP-1125
5-1-6. Operation Menu
(Factory default settings are indicated by a
\ \
\ \ \ mark.)
Item Description
IN-V Selects input video mode.
\
D1: Selects D1 SDI input mode (525/626).
D2: Selects D2 SDI input mode (525).
ANA: Selects NTSC ANALOG input mode (525).
REF Selects the reference of the HD-SDI output signal.
\ INPT: Sets the INPUT VIDEO as the reference.
REFA: Sets the REF IN A of the connector board on the PFV-SP series as the reference.
REFB: Sets the REF IN B of the connector board on the PFV-SP series as the reference.
n
When the REFA or REFB is selected as the REF signal, and when its selected signal is not inputted, the
INPT is selected automatically.
EX-R Selects the format of the reference input signal.
\ HD _: Tri-level sync signal
SD _: 525/625 black burst signal
CONV Selects the conversion mode.
\ ADP: Adaptive (Motion adaptive field/frame conversion)
FLD: Converts at field fixation.
FRM: Converts at frame fixation.
M-SE Adjusts the motion detection sensitivity during converting. (This mode is effective only when CONV is set
to ADP.)
By this sensitivity, the conversion ratio from Frame or Field at the time of conversion can be changed. If a
numerical value is enlarged, the sensitivity of motion sensor becomes high. As the result, the portion
processed as the animation increases. (When the output mode is 720p, 2 to 4 can only be selected.)
1: adaptive2 (Still picture priority mode)
2: adaptive1-S
\ 3: adaptive1 (Standard mode)
4: adaptive1-M
5: adaptive3 (Animation priority mode)
ASPC Selects the aspect mode.
OFF: Edge Crop mode (Default)
\
ON: Opens the aspect menu.
ASPE Selects the aspect ratio.
\ ECN: Edge Crop mode
LB:
Letter Box mode
SQ: Squeeze mode
ECPC Edge Crop Position Control
OFF: Fixed to center.
\ ON: Variable
EC-P Adjusts the Edge Crop position. (In the units of 2 pixels.)
Factory setting: 0
Setting range:
_ 240 to +240 (at 1080 output)
_ 160 to +160 (at 720p output)
LBPC Letter Box Position Control
OFF: Fix to center.
\ ON: Variable
LB-P Adjusts the Letter Box Position (This mode is only effective when LBPC is set to ON.)
Factory setting: 0
Setting range:
_
31 to +32 (at 1080i/59.94 output, and the center is 52 lines.)
_
36 to +36 (at 1080i/50 output, and the center is 59 lines.)
_
30 to +30 (at 720p output, and the center is 52 lines.)
n
The variable can be performed in the unit of one line. When the setting is set to maximum value, the
picture is positioned to the lower most position, and set to minimum value, the picture is positioned to the
upper most position.