4
Low-latency output
All signal processing is performed within a single frame, and
the output video is delayed by one frame.
When the frame synchronizer function is on, the output is
delayed by two frames.
(When 4K is output as SQD signals, there is a further one
frame delay.)
Minimum delay setting
When the system frequency is 59.94/50 and the input/output
signal setting is 4K (2SI), enabling minimum delay mode
causes a delay in 4K output of only a few lines (in HD signal
terms). When the system frequency is 29.97/25/24/23.98 and
an SQD signal is set for 4K input/output signal, the 4K output
delay is one frame or higher (same as minimum delay mode
not being enabled).
HD×4 input mode
You can use 4K INPUT connectors as four HD inputs.
This is supported only when the input format is 1080/59.94P,
50P, 59.94i, 50i, 29.97PsF, 25PsF, 24PsF, or 23.98PsF on four
channels, and all four inputs must be in the same format. The
OETF setting of the outputs cannot be set individually.
For HD×4 input, prioritize use of the CH-1 input and CH-3
input. If there is no input on CH-1, CH-2 to CH-4 cannot be
used. If there is no input on CH-3, CH-4 cannot be used.
One of the four systems among the 4K INPUT 1 to 4
connectors can be selected for output on the HD OUT
connector.
Through mode setting
In through mode, SDI signals input on the 4K input connectors
(BNC × 4) are output on the 4K output connectors (BNC × 4)
with a 1-line delay (in HD signal terms). The 4K INPUT 1
connector signal is output as-is on the HD output. However,
720P input is not supported.
16-channel embedded audio support
Audio signals (16-channel) can be embedded in the SDI
signals.
The audio signal with a delay matching the video signal is
embedded in the output signal.
Remote control
Supports the remote control by Sony system camera products.
Format setting, HDR/SDR setting, OETF setting, color space
setting, image quality setting, file operation, and menu
operation are supported from an RCP-1500 series Remote
Control Panel or an MSU-1000 series Master Setup Unit.
Configuration file
The settings of the SETUP menu and ADDITIONAL PAINT
menu within the unit can be stored in up to five scene files
each for channel A and channel B. The settings in the
CONFIGURATION menu, SETUP menu, and ADDITIONAL
PAINT menu can also be stored in up to 32 configuration files
as an all-settings file.
The exporting and importing of each file can be controlled from
an RCP-1500 series Remote Control Panel or an MSU-1000
series Master Setup Unit.
Furthermore, an all-settings file can be recalled from the I/O
PORT connector (D-sub 15-pin).