Attaching a Lens
16
Attaching a Lens
The projector comes from the factory with no lens
attached. You can attach the following types of optional
lenses to the projector:
• VPLL-Z4019 Standard Zoom Lens
• VPLL-4008 Fixed Short Focus Lens (for rear
projection, optical axis angle 0 degrees))
• VPLL-Z4015 Short Focus Zoom Lens
• VPLL-Z4025 Middle Focus Zoom Lens
• VPLL-Z4045 Long Focus Zoom Lens
Attaching a Lens
Follow the steps below to attach a lens:
For details on the lens, also refer to the operating
instructions supplied with the lens.
1
Turn off the power of the projector and disconnect
the power cable.
2
Remove the lens cover.
1
Remove the lens hole cover.
2
Loosen the two screws at the bottom.
3
While lifting the lens cover, pull it toward you
to remove. (The lens cover is fixed to the
projector with two tabs on the top.)
3
Move the lens fixing lever upward to unlock.
Note
Move the lens fixing lever completely upward.
Otherwise you cannot attach or remove the lens.
4
Remove two lens caps and insert the lens straight
with a white circle mark up, as far as it goes.
Notes
• Attach the lens carefully so as not to damage the
lens glass with the lever or other parts.
• If the lens does not go in fully, turn the lens
slightly right and left.
5
Move the lens fixing lever down to the bottom
correctly.
The lens is locked.
If the lens fixing lever does not move down, the lens
may not be fully inserted. Insert it again and move
the lens fixing lever down to the bottom correctly.
Lens cover
2
1
3
Lens fixing lever
White circle mark
