40
<HD CUTOUT>
S08
S10 (When HKCU-IP43F
or HKCU-4001 is
installed)
HD CUTOUT
OFF
, ON
Turns the HD cutout function ON/OFF.
Enabled only when HDC(HD CUTOUT) is selected in
CHU MODE.
The cutout HD signal from the 4K source is output
from SLOT1.
MODE
SIMPLE HD
,
ZOOM&PERSPECTIVE
Selects the cutout mode.
SIMPLE HD:
Outputs a 1920x1080 HD region cutout
from the 4K video as-is. Dual output is supported.
The cutout signal set by the CUTOUT POSITION
CH1 setting is output from the 1/2 connector and 5/6
connector of Slot1, and the cutout signal set by the
CUTOUT POSITION CH2 setting is output from the
3/4 connector and 7/8 connector of Slot1.
ZOOM&PERSPECTIVE:
Outputs an HD signal
formed by zooming in or out of the cutout region from
the 4K video. In this mode, a perspective
transformation is performed according to the focal
length of the lens, and an image similar to the image
obtained by the camera facing the cutout direction is
output.
CUTOUT CH
1
, 2
Selects the cutout position channel.
Only channel 1 is available when
ZOOM&PERSPECTIVE is selected.
CENTER H
–1536 to 1535,
0
Specifies the cutout position center (horizontal
direction, 0: center).
(Setting when MODE is ZOOM&PERSPECTIVE,
CUTOUT POSITION ZOOM is 4.0, and FOCAL
LENGTH is Infinity)
CENTER V
–810 to 809,
0
Specifies the cutout position center (vertical
direction, 0: center).
(Setting when MODE is ZOOM&PERSPECTIVE,
CUTOUT POSITION ZOOM is 4.0, and FOCAL
LENGTH is Infinity)
ZOOM
1.0 to 4.0,
2.0
Specifies the zoom factor (1.0: same position as the
4K video)
Enabled only when ZOOM&PERSPECTIVE is
selected.
CAMERA TILT
–45.0 to 45.0,
0
Specifies the tilt angle of the camera (0: horizontal,
positive angles represent upward tilt)
Enabled only when ZOOM&PERSPECTIVE is
selected.
CAMERA ROLL
–5.0 to 5.0,
0
Specifies the roll angle of the camera (0: horizontal,
positive values represent counterclockwise roll)
Enabled only when ZOOM&PERSPECTIVE is
selected.
FOCAL LENGTH
7
to 500,
∞
Specifies the focal length of the lens (unit: mm)
To avoid shape change due to perspective
transformation, increase the focal length until
“INFINITY” is displayed.
Enabled only when ZOOM&PERSPECTIVE is
selected.
<SR Live
METADATA(OUTPUT)>
S09
S11 (When HKCU-IP43F
or HKCU-4001 is
installed)
META
OFF
, ON
SR Live metadata embed on/off setting
1st F
LINE9 to LINE20,
LINE14
Line number used in 1st field
2nd F
LINE572 to LINE583,
LINE577
Line number used in 2nd field
SYSTEM OPERATION
Page name
Page No.
Item
Set value
Indication
